User`s guide
To assign any currently selected Parameter to a footswitch or Expression pedal in the
currently selected bank, do the following:
1. Be sure that the Parameter you want to link is displayed and selected (below is an example the gain setting of the Tube Distortion
module.). The display should appear something like this:
2. Turn the <4> knob to select the gain parameter, then press the <Assign> button once. The display reads:
3. Select the footswitch or move the expression pedal to be used. An example would be to use Exp 1. From there, use knobs <3>
and <4> to set the minimum and maximum ranges of the gain. Once this is done, the display will appear something like this:
4. To exit the parameter assignment mode press the <Program> button to return to Program mode. The <Store> button will stay
bright until these changes are stored, or the program is changed.
Other Footswitch Functions
The footswitches on the 2120 FC can be assigned to do several functions. This is done through the Foot Controller menus in the Utilities
section of the 2120. These functions include:
Gain Exp 2 Min[ 69]Max
2
FACTORY USER
On
1
CHANGEDLINK
Pdl
2
CHANGEDLINK
20
3
CHANGEDLINK
55
4
CHANGEDLINK
1
OF
19
COMP WAH TUBE EQ
L/R OUTS
L/R OUTS
DIGITAL
CLIP
#
b
GATE
SEAMLESS
BANK
Gain Exp 1 Min[ 56]Max
2
FACTORY USER
On
1
CHANGEDLINK
Pdl
2
CHANGEDLINK
0
3
CHANGEDLINK
100
4
CHANGEDLINK
PAGE
1
OF
19
COMP WAH TUBE EQ
L/R OUTS
L/R OUTS
DIGITAL
CLIP
#
b
GATE
SEAMLESS
Type: Bright Clean Gain
2
FACTORY USER
1
CHANGEDLINK
1
2
CHANGEDLINK
3
CHANGEDLINK
55
4
CHANGEDLINK
PAGE
2
OF
2
COMP WAH TUBE EQ
L/R OUTS
L/R OUTS
DIGITAL
CLIP
#
b
GATE
SEAMLESS
Section - 5 The 2120 FC
2120 VGS Artist
User Guide
52