Two Channel 48 Volt Phantom Power Supply Artcessories User's Manual
IMPORTANT SAFETY INSTRUCTION – READ FIRST This symbol, whenever it appears, alerts you to the presence of uninsulated dangerous voltage inside enclosure-voltage that may be sufficient to constitute risk of shock. This symbol, whenever it appears, alerts you to important operating and maintenance instructions in the accompanying literature. Please read the manual. Read Instructions: Retain safety and operating instructions for future reference. Heed all warnings printed here and on the equipment.
Installation: Install the unit in accordance with the instructions printed in the user guide.
INTRODUCTION: Thanks for purchasing Applied Research and Technology’s PHANTOMIIPRO offering a superb level of sound quality.The PHANTOMIIPro is designed to do one thing and do it well. It provides clean, reliable phantom power for one or two condenser microphones in a rugged, compact, and portable unit. Innovative low power circuitry generates the higher voltage necessary for powering microphones while maximizing battery life.
FEATURES: • • • • • • XLR connectors for balanced inputs and outputs Low power, high efficiency CMOS circuitry for long battery life using a standard 9-Volt battery (Alkaline recommended) Can be powered with an external power supply for operation from AC mains Rugged extruded aluminum case with easily accessible battery compartment LED lighted On/Off switch Low noise, low distortion circuitry
INSTALLATION and OPERATION: 1. Install a battery in the unit by unscrewing the knurled fastener to open the 9V BATTERY compartment and snapping the connector on to the battery. Alternatively, connect an external power supply to the EXTERNAL POWER jack. The PHANTOMIIPro is protected in case both sources of power are applied at the same time. 2. Connect the cable from your microphone to the MICROPHONE INPUT 1 or 2 female XLR connector on the front panel. 3.
Signal Flow Chart
SPECIFICATIONS: Input Connections: Output Connections: Phantom Power Voltage: Current Limiting Resistors: Power Source: Current Drain: Battery Life: Dimensions HxWxD (in): HxWxD(mm): Weight (lbs/kg): Female XLR (2) Male XLR (2) 48 Volts DC typical 6.98k Ohms (1%) 9V battery (IEC 6LR61, ANSI-1604A type Alkaline recommended) or external supply 7.512 V AC/DC, Any Polarity, < 150 mA 10 mA - no load, 45 mA typical (full load - 2 microphones) >10 hours with Alkaline Battery - typical (full load) 1.85 x 4.
WARRANTY INFORMATION: Limited Warranty (USA only) Applied Research and Technology will provide warranty and service for this unit in accordance with the following warrants: Applied Research and Technology, (ART) warrants to the original purchaser that this product and the components thereof will be free from defects in workmanship and materials for a period of three years from the date of purchase.
specific rights and you may have other rights, which vary, from state to state. The warranty terms listed above are only valid within the United States of America. For units purchased outside the United States, an authorized distributor of Applied Research and Technology will provide service. For information on warranty and service policies outside of the U.S., please contact your local distributor.
SERVICE: The following information is provided in the unlikely event that your unit requires service. 1. 2. 3. 4. Be sure that the unit is the cause of the problem. Check to make sure that the unit has power supplied, that all cables are connected correctly, and that the cables themselves are in working condition. You may want to consult with your dealer for assistance in troubleshooting or testing your particular configuration. If you believe that the ART unit is at fault, go to www.artproaudio.com.
www.artproaudio.com E-mail: support@artproaudio.com © 2014 Applied Research & Technology PHANTOMIIPro P2P-5004-101 V1.