User Guide

- 7 -
AMP MODE SWITCH
The SLA-1 Amp Mode Switch allows you to choose between Stereo
Mode and Bridge Mono Mode. Make sure that power is off and that
your speakers are wired appropriately when changing this mode.
OUTPUT BINDING POST
The SLA-1 Outputs for channels one and two are multi-connection
jacks. You can use banana jacks, spade connectors or bare wire.
Bare Wire Connections – unscrew the red and black caps on the
binding posts (don’t completely remove). Strip back the wire cable
insulation ½”, then inset the bare wire into the hole on the top of the
plastic assembly. Once it is in, screw the binding post cap down on the
wire. Be sure the wire connected to one post does NOT
come in
contact with that of another.
Spade Connector – Unscrew the red and black caps on the binding
posts (don’t completely remove). Insert the spade connector into the
binding post and tighten the caps down on the spade connector. Be
sure the wire connected to one post does NOT
come in contact with
that of another.
Banana Plug – Insert the banana jacks into the caps of the binding
posts. Be sure that the red and black caps on the binding posts are
tightened down completely and that they are securely connected to
avoid the possibility of them popping out.
SMARTFAN™
The SLA-1 features SmartFan™, an advanced, thermal dependent
convection cooling, silent fan assisted system. The SmartFan™
system is dependent upon the internal ambient temperature inside the
unit, and runs at two different levels. The SmartFan™ system is
extremely quiet…you probably won’t even hear it working.
Do not block the fan or constrict air circulation in any way. Doing so
may cause the amp to overheat and/or shutdown.