User Guide

- 8 -
FUSE
The SLA-1 utilizes a 7 Amp fuse. Be sure to replace any blown fuses
with a fuse of equal rating only.
AC POWER INPUT
The SLA-1 features an internal power supply. Plug the detachable
cable into a standard 110~120v wall outlet. Be sure that the supplied
voltage matches that of the required voltage of your amplifier. Never
plug the amp into an outlet that does not match the required voltage of
your amplifier. Serious damage could result.
GROUND LIFT SWITCH
This switch is used to disconnect the internal ground signal from the
chassis (case) ground. This may be used to reduce 60Hz noise (hum
or buzz). Normally you would ground the chassis, for best shielding.
When the SLA-1 is mounted in a grounded rack of equipment, the
ground to the case may be lifted to prevent multiple ground paths,
which may cause a ground loop to occur.
Fill in the following information for your reference:
Date of purchase ___________________
Purchased from ___________________
SERIAL NUMBER ___________________