User Guide

- 9 -
OPERATION
The main application of the SLA-1 is as a studio linear power amplifier
for powering monitors. Plug source material directly into the inputs and
set the output controls to provide an appropriate level into the next
stage of your system (and an excellent choice for this are the ART
SLM-1 Studio Linear Monitors).
NORMAL OPERATION
For a typical stereo setup, connect the source (mixer, eq, etc) outputs
into channels one and two of the amplifier. Connect your speakers to
the outputs on the rear of the amplifier. Be sure that your front gain
controls are turned down to their lowest level (full counter-clockwise).
Turn the amp on, then slowly turn the input level up. Use your front
gain controls to regulate the output volume. Be sure not to raise the
volume to the clip level; however, an intermittent clip signal is
acceptable.
MONO BRIDGE OPERATION
Be sure the amp is shut off. Press the Stereo/Mono switch (on the
back) to the “in” position. Connect an input signal to channel one.
Connect your speaker across the red output binding post on the rear of
your amplifier. Turn your equipment on – your amplifier should be the
last piece you turn on (be sure it’s volume is turned down). Apply an
input signal to your amplifier. Use channel one’s attenuator to adjust
your amplifier output level.