Microphone Splitter / Combiner Artcessories User's Manual
IMPORTANT SAFETY INSTRUCTION – READ FIRST This symbol, whenever it appears, alerts you to the presence of uninsulated dangerous voltage inside enclosure-voltage that may be sufficient to constitute risk of shock. This symbol, whenever it appears, alerts you to important operating and maintenance instructions in the accompanying literature. Please read the manual. Read Instructions: Retain safety and operating instructions for future reference. Heed all warnings printed here and on the equipment.
Installation: Install the unit in accordance with the instructions printed in the user guide.
INTRODUCTION: Thank you for purchasing Applied Research and Technology’s SPLITComPRO. The ARTcessories SPLITComPro is an ideal audio utility to use in an application where you need to split a low impedance microphone signal to feed two separate mixers, or where it’s necessary to combine balanced low impedance microphone signals from two microphones into a single channel input.
APPLICATIONS: AS A SPLITTER: The SPLITComPro provides one direct-coupled output and one isolated output from a single microphone. Applications include sending the direct output to the main or FOH mixer, and the second isolated output to a monitor or recording mixer. The MAIN MIC OUTPUT passes phantom power from the main mixer to the MAIN MIC INPUT for use with condenser microphones. Phantom power is blocked from passing to the ISOLATED MIC OUTPUT.
due to ground loops between connected AC-powered units.
SPECIFICATIONS: Frequency Response : 20Hz to 150kHz +/- 0.2 @ 0dBu THD: Less than 0.0007% from 20Hz to 20kHz at 0dBu input Phase Shift: Less than 10° at 20 to 150kHz (reference 1kHz) Typical Driving Source Dist.: 150 Ohms Typical Output load Impedance: 1k Ohms Dimensions HxWxD(in): 1.85 x 4.6 x 3.5 Dimensions HxWxD(mm): 47 x 117 x 89 Weight (lbs/kg): .75 / .
WARRANTY INFORMATION: Limited Warranty (USA only) Applied Research and Technology will provide warranty and service for this unit in accordance with the following warrants: Applied Research and Technology, (ART) warrants to the original purchaser that this product and the components thereof will be free from defects in workmanship and materials for a period of three years from the date of purchase.
or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific rights and you may have other rights, which vary, from state to state. The warranty terms listed above are only valid within the United States of America. For units purchased outside the United States, an authorized distributor of Applied Research and Technology will provide service. For information on warranty and service policies outside of the U.S., please contact your local distributor.
SERVICE: The following information is provided in the unlikely event that your unit requires service. 1. Be sure that the unit is the cause of the problem. Check to make sure that the unit has power supplied, that all cables are connected correctly, and that the cables themselves are in working condition. You may want to consult with your dealer for assistance in troubleshooting or testing your particular configuration. 2. If you believe that the ART unit is at fault, go to www.artproaudio.com.
www.artproaudio.com E-mail: support@artproaudio.
SCP-5004-101 V1.
