User Manual

FIGURE 5 – Output Section
Sample Rate/Dither Control
The SAMPLE RATE/DITHER knob selects the sample rate for the AES/EBU, S/PDIF, and optical outputs. It
also selects the dither applied. Set the switch appropriately to match up with 16 or 24 bit encoding.
NOTE: This control does NOT affect the USB output.
Optical Output Switch
The OPTICAL OUTPUT switch sets the signal format of the rear panel OPTICAL OUTPUT connector. In
ADAT mode channels 1 and 2 are the “left” and “right” A/D outputs of the Voice Channel™ respectively. NOTE:
If the A/D insertion jacks are not being used, both channels 1 and 2 carry the same signal. If the ADAT INPUT
is also being used, channels 3 thru 8 are passed through along with channels 1 and 2 of the ART Voice
Channel™.
FIGURE 6 – Rear Panel
11