Installation Guide

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
CL1364
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER
WHILE INSTALLING OR SERVICING THIS FIXTURE
.
NOTE: Before installing, consult local electrical codes for wiring and grounding requirements.
Installation Steps
1. Shut off power at the Fuse Box or Circuit Breaker Box. Remove the old fixture from ceiling, including the Crossbar.
2. Carefully unpack your new Fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary
for installation.
3. Thread the two Mounting Screws . about 1/4” into the pre-drilled holes in the Crossbar spaced the same distance apart as
the holes in the Ceiling Pan .
4. Attach the Crossbar to the Outlet Box using the two Screws from the Outlet Box. The side of the Crossbar marked
“GND” must face out.
5. While holding the Ceiling Pan toward the ceiling, connect the electrical wires as follows. Connect the black wire from
the fixture to the black house (hot) wire. Connect the white wire from the fixture wire to the white (neutral) house wire.
Make sure all wire nuts are secured. You may wrap the connections with electrical tape. If your outlet has a ground wire
(green or bare copper) connect fixtures Ground Wire to it. Otherwise connect Fixture’s Ground Wire directly to the
Crossbar using the Green Screw provided. Tuck the wire connections neatly into the ceiling Junction Box as you hold the
Ceiling Pan assembly toward the Ceiling.
6. Finish mounting the Ceiling Pan by placing it over both Mounting Screws so that they protrude through the “keyholes” in
the bottom of the pan. Rotate the Pan until the screws are in the slots of the “keyholes” and tighten with a screwdriver.
7. Thread Hex Nut over Nipple and then thread Nipple into Coupling . Tighten hex nut against coupling.
Note: Some adjustment in nipple length may be necessary.
8. Install the lighting bulbs in accordance with the fixture’s specifications. DO NOT EXCEED THE MAXIMUM
WATTAGE RATING!
9. Thread the crystal strings onto the canopy and the cap .
10. Your installation is now complete. Return power to the Junction Box and test the Fixture.
NOTE: All parts must be used as indicated, and the physical integrity
must be maintained to insure ETL/CETL listing of this fixture.
WARNING:
CAP
WIRE CONNECTOR
OUTLET BOX
CIRCULAR STRAP
GREEN GROUND SCREW
WIRE CONNECTOR
SCREW
FIXTURE GROUND WIRE
SUPPLY WIRE
FIXTURE WIRE
CRYSTAL STRINGS
CEILING PAN