user manual Washing Machine AWF 5120 W
electrolux Electrolux. Thinking of you. Share more of our thinking at www.electrolux.
electrolux 3 • All packing and transit bolts must be removed before use. Serious damage can occur to the product and to property if this is not adhered to. See relevant section in the user manual. • After having installed the appliance, check that it is not standing on the inlet and drain hose and the worktop is not pressing the electrical supply cable against the wall. • If the machine is situated on a carpeted floor, please adjust the feet in order to allow air to circulate freely under the appliance.
electrolux Product description Your new appliance meets all modern requirements for effective treatment of laundry with low water, energy and detergent consumption. Its new washing system allows total use of detergent and reduces water consumption so saving energy. 1 2 3 4 5 6 1 Detergent dispenser drawer 2 Control panel 3 Door opening handle Detergent dispenser drawer Compartment for detergent used for prewash and soak phase or for stain remover used during the stain action phase (if available).
electrolux 5 Control panel Below is a picture of the control panel. It shows the programme selector dial as well as the temperature selector dial, the buttons and the pilot lights. These are presented by relevant numbers on the following pages.
electrolux = Washing = Door locked = End of Cycle Programme Selector Dial It allows you to switch the appliance on/off and/or to select a programme. Temperature selector dial This dial allows you to select the temperature more suitable to the laundry to be washed. the machine will By selecting the position wash with cold water. Spin speed Reduction By pressing this button you can reduce the maximum spin speed allowed for the selected programme or to select the available option(s).
electrolux 7 - light flashing: the door is opening. When the programme has finished the pilot light 8.3 (End) comes on. First use • Ensure that the electrical and water connections comply with the installation instructions. • Remove the polystyrene block and any material from the drum. • Pour 2 liters of water into the main wash compartment of the detergent drawer in order to activate the ECO valve.
electrolux Select the required programme by turning the programme selector dial (1) Turn the programme selector dial to the required programme. The washing machine will automatically select the maximum spin value provided for the programme you have chosen. You can change this value by pressing the corresponding button. The green pilot light of the button 6 starts to flash. The selector dial can be turned either clockwise or counterclockwise.
electrolux 9 To interrupt a programme which is running, press the button 6 : the corresponding green pilot light starts blinking. To restart the programme from the point at which it was interrupted, press the button 6 again . If you have chosen a delayed start, the machine will begin the countdown. If an incorrect option is selected, the red pilot light of the button 6 blinks for 3 times. Altering an option or a running programme It is possible to change some options before the programme carries them out.
electrolux Washing programmes Programme - Maximum and Minimum Temperature - Cycle Description - Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry Options COTTONS 90° - Cold1) Main wash - Rinses Maximum spin speed at 500 rpm Max. load 5 kg - Red. load 2,5 kg 2) White and coloured cotton (normally soiled items). SPIN REDUCTION NO SPIN RINSE HOLD PREWASH3) ECONOMY4) SUPER QUICK EXTRA RINSE SYNTHETICS 60° - Cold Main wash - Rinses Maximum spin speed at 500 rpm Max. load 2 kg - Red.
electrolux 11 Programme - Maximum and Minimum Temperature - Cycle Description - Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry SILK 30° Main wash - Rinses Maximum spin speed at 500 rpm Max. load 1 kg Delicate washing programme suitable for silk and mixed synthetic items. Options SPIN REDUCTION NO SPIN RINSE HOLD SOAK 30° Prewash - Soak for about 40 minutes - Stop with water in the tub Max. load 5 kg Special programme for heavily soiled laundry. The machine performs a soak at 30°C.
electrolux Programme - Maximum and Minimum Temperature - Cycle Description - Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry DELICATE RINSES Rinse with fabric softener if needed Maximum spin speed at 500 rpm Max. load 2 kg With this programme it is possible to rinse and spin garments which have been washed by hand. The machine performs a rinse, followed by a final short spin. Options Detergent Compartment SPIN REDUCTION NO SPIN RINSE HOLD EXTRA RINSE DRAIN Draining of water Max.
electrolux 13 Button up pillowcases, close zip fasteners, hooks and poppers. Tie any belts or long tapes. Remove persistent stains before washing. Rub particularly soiled areas with a special detergent or detergent paste. Treat curtains with special care. Remove hooks or tie them up in a bag or net. Removing stains Stubborn stains may not be removed by just water and detergent. It is therefore advisable to treat them prior to washing. Blood: treat fresh stains with cold water.
electrolux from your local authority. If the water hardness degree is medium or high we suggest you to add a water softener following always the manufacturer’s instructions. When the degree of hardness is soft, readjust the quantity of the detergent. Care and cleaning Warning! You must disconnect the appliance from the electricity supply, before you can carry out any cleaning or maintenance work. the top part of the additive compartment should be removed.
electrolux 15 Drain pump The pump should be inspected regularly and particularly if: • the machine does not empty and/or spin • the machine makes an unusual noise during draining due to objects such as safety pins, coins etc. blocking the pump. Proceed as follows: 1. Disconnect the appliance. 2. If necessary wait until the water has cooled down. 3. Open the pump door. 6. Insert the detergent dispenser drawer in the guide rails and push it in.
electrolux keep a rag nearby to dry up spillage of water when removing the pump. 7. Remove any objects from the pump impeller by rotating it. Cleaning the water inlet filter If you notice that the machine is taking longer to fill, check that the filter in the water inlet hose is not blocked. 1. Turn off the water tap. 2. Unscrew the hose from the tap. 3. Clean the filter in the hose with a stiff brush. 4. Screw the hose back onto the tap. 8.
electrolux 17 1. close the water tap and unscrew the water inlet hose from the tap; 2. place the end of the emergency emptying hose and that of the inlet hose in a bowl placed on the floor and let water drain out; 3. screw the water inlet hose back on and reposition the emergency emptying hose after having put the cap on again. By doing this, any water remaining in the machine is removed, avoiding ice forming and consequently damage to the appliance.
electrolux Problem Possible cause/Solution The drain hose is squashed or kinked (the button 6 red light blinks). • Check the drain hose connection. The drain filter is clogged (the button 6 red light blinks). • Clean the drain filter. The machine does not empAn option or a programme that ends with the water still in the tub or ty and/or does not spin: a that eliminates all the spinning phases has been selected. • Select the draining or spinning programme.
electrolux 19 Problem Possible cause/Solution The machine makes an unusual noise: The machine is fitted with a type of motor which makes an unusual noise compared with other traditional motors. This new motor ensures a softer start and more even distribution of the laundry in the drum when spinning, as well as increased stability of the machine. No water is visible in the drum: Machines based on modern technology operate very economically using very little water without affecting performance.
electrolux Programme Energy consumption (KWh) Water consumption (litres) Programme duration (Minutes) Synthetics 40° 0.4 42 75 Delicates 40° 0.5 57 65 Wool/ Handwash 30° 0.2 53 50 1) «Cottons + Economy» at 60°C with a load of 5 kg is the reference programme for the data entered in the energy label, in compliance with EEC 92/75 standards.
electrolux 21 4. Slide out the relevant plastic spacers. 6. Fill the smaller upper hole and the two large ones with the corresponding plastic plug caps supplied in the bag containing the instruction booklet. 5. Open the porthole and remove the polystyrene block fitted on the door seal. Positioning Install the machine on a flat hard floor. Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen units.
electrolux levelling prevents vibration, noise and displacement of the machine during operation. Angle the hose to the left or right depending on the position of your water tap. Caution! Never place cardboard, wood or similar materials under the machine to compensate for any unevenness in the floor. 3. Set the hose correctly by loosening the ring nut. After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks. The inlet hose must not be lengthened.
electrolux 23 • Hooked over the edge of a sink using the plastic hose guide supplied with the machine. In this case, make sure the end cannot come unhooked when the machine is emptying. This could be done by tying it to the tap with a piece of string or attaching it to the wall. • In a sink drain pipe branch. This branch must be above the trap so that the bend is at least 60 cm above the ground. • Directly into a drain pipe at a height of not less than 60 cm and not more than 90 cm.
electrolux The power supply cable must be easily accessible after installing the machine. Environment concerns The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment.
electrolux 25
electrolux
electrolux 27
www.electrolux.
