Specifications

2.3 MDR Board Switch and Jumper Locations
The default switch and jumper settings on the MIDAS boards for the MDR base units at
shipment are as shown in the figure below:
i960RD
#2
i960RD
#1
UNIVERSE
VME-TO-PCI
PXB
JP1 JP2
JP4
JP5
JP14
JP7
JP9
JP15 JP3 JP6 JP10 JP13 JP11
SW1
RST DIS
BASE ADDR
BOOT
SFAIL
A
UTO ID
VRAI
FLASH RACEway INT
ASIZE
PMC #2
PMC #1
INTERRUPT
JUMPERS
RACEway
JUMPERS
FLASH
JUMPERS
VMEbus CONFIGURATION
JUMPERS & SWITCH
BOOT MODE
SELECTION
Note that darkened rectangles indicate the jumper is installed. For a complete discussion
of each jumper and switch, refer to the MIDAS 100/200 Series User’s Manual.
12 MDR User Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com