Specifications

84 MDR User Guide
10.7.1.1 Boot parameters preload
If it is necessary to preload boot parameters, use a terminal emulator which provides the
XMODEM protocol to communicate with the MDR through its front-panel serial port;
9600 bps, 8 data bits, 1 stop bit no parity, no flow control.
Following the board's self-test, the MDR unit will present a short countdown to permit
you to enter the MIDAS monitor:
Press any key to interrupt the countdown and then press the Enter key 2 or 3 times
within 2 seconds (to perform autobaud). The MIDAS monitor prompt # should then
appear.
Clear the old boot parameters with the
del command:
#del vxbp.txt
This will take some time while the FLASH is updated.
Upload the new boot parameters with the
mgf command:
#mgf vxbp.txt <size>
where
<size> is the size of the desired boot-parameter file to be uploaded. The MIDAS
monitor will begin an XMODEM receive. Instruct your terminal program to begin an
XMODEM send of the file containing the boot parameters you wish to use. Once the file
is sent, there will be a pause while the new vxbp.txt file is written to FLASH.
When the MIDAS Monitor prompt returns, check the contents of the file, use the
more
command:
#more vxbp.txt
Exit the monitor with the quit command:
#quit
The MDR unit will reboot. This time, allow the countdown to expire and the MDR
firmware will begin executing.
You may also need to add or change some items related to your host network in order to
communicate with the MDR. In particular, host tables and gateway information must be
updated as appropriate. Consult your system administrator and/or your local network
documentation for information and instructions.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com