Specifications
E-500/E-501 Series PZT Servo Controllers User Manual PZ 62E
Release 2.15.1 www.pi.ws Page 14
4. Handling
4.1. Unpacking Checklist
The E-500/E-501 system was carefully inspected, both electrically and mechanically, before
shipment. Upon receiving the device, unpack it and check for any obvious signs of physical
damage that may have occurred during transit.
Retain and use the original packing material in case reshipment is necessary.
The following items are shipped with every E-500/E-501 system:
• Chassis with modules installed.
• Power cord
• PZ62E User Manual (this document)
• E500T0011 Technical Note for GCS LabVIEW driver set for analog controllers
If one or more E-509 modules are installed, you should also have these items:
• PZ77E Manual for E-509
• With all models except for E-509.E03: PZ150E Manual for E-802 Servo-Controller
Submodule
• With E-509.Sx and .S31 models only: PZ117E Manual for E-801 Sensor Submodule
• With E-509.S3 and .S31 models only: E-808.90 sensor monitor cable
• With E-509.CxA models only: PZ106E Manual for Capacitive Sensors
• With E-509.CxA, .E03 and .E3 models only: D-893.32 sensor monitor cable
• With E-509.E03 and .E3 models only: 3214 banana plug for ground connection of the
sensor reference plane
If an E-517 module is installed, you should also have these items:
• C-815.34 RS-232 cable
• C-815.563 crossover network cable
• 000011448 USB cable
• 4347 and 4348 MDR connector for I/O socket
• E-517.CD product CD with software and manuals for E-517
• PZ214EQU User Manual for E-517, short version
• A000T0028 Technical Note for the PI Update Finder
• A000T0032 Technical Note for Using the PI Update Finder without Internet connection
4.2. Safety Measures for Installation, Start-Up and Operation
Improper installation of the E-500/E-501 system can result in personal injury and/or damage
to the E-500/E-501 system.
Install the E-500/E-501 system near the power source so that the power plug can be
quickly and easily disconnected from the mains.
Use the supplied power cord to connect the E-500/E-501 system to the power source.
If the supplied power cord has to be replaced, use a sufficiently dimensioned
component.
Only use cables and connections that meet local safety regulations.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com