Specifications

E-500/E-501 Series PZT Servo Controllers User Manual PZ 62E
Release 2.15.1 www.pi.ws Page 37
Labeling Type Function
CONTROL INPUT
E-508.00: BNC
E-508.OE: SMB
In analog operation, this control input voltage gives the target
(either as voltage or position, depending on the servo mode).
Input voltage range:
 Servo off: ±1/100 of selected output range
 Servo on: 0 to 10 V
With E-508.00, the control input range can be shifted using the
“DC-OFFSET” potentiometer.
The control input voltage can also be a computer-generated
analog signal (e.g. from a DAQ board). You can use a PI
LabVIEW Analog Driver set to generate that analog signal.
See “Analog Operation” on p. 17 for details.
See the „Specifications“ table below for the input voltage
range.
PZT
High Voltage
LEMO
EGG.0B.701.CJL.1173
Pinout on p. 39
Output of the piezo voltage for the piezo actuator in the stage.
See the „Specifications“ table below for the output voltage
range.
5.7.2. Operating Limits
Fig. 18: E-508 operating limits with various piezo loads (open-loop), capacitance is
measured in nF
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com