Specifications

E-500/E-501 Series PZT Servo Controllers User Manual PZ 62E
Release 2.15.1 www.pi.ws Page 66
an amplifier switching frequency of 100 kHz, the sampling rate must be 200 kHz or higher.
If the sampling rate provided by your oscilloscope is not high enough, use a low-pass filter
at the oscilloscope input to eliminate frequencies above 100 kHz. Alternatively, you can use
an analog oscilloscope or perform high-resolution measurements in the lower frequency
range.
When following those instructions, you will obtain valid measurement results.
10.3. EC Declaration of Conformity
For the E-500/E-501, an EC declaration of conformity according to the following European
directives was issued:
2006/95/EC, Low Voltage Directive (LVD)
2004/108/EC, EMC Directive
2011/65/EC, RoHS Directive
The applied standards certifying the conformity are listed below.
Electromagnetic Emission: EN 61000-6-3:2007, EN 55011:2009
Electromagnetic Immunity: EN 61000-6-1:2007
Safety (Low Voltage Directive): EN 61010-1:2010
If electrical equipment is intended to be integrated in other electrical equipment: The user is
responsible for compliant connection of the electrical equipment when implementing the
total system.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com