Specifications

CP302 CP-RIO3-01 Rear I/O Module
ID 21112, Rev. 05Page D - 8 ® PEP Modular Computers GmbH
D.4.3 VGA Interface
Figure D-6: D-sub VGA Connector
D.4.3.1 VGA Connector CON5 Pinout
The 15-pin female connector CON5 is used to connect a VGA monitor to the
CP-RIO3-01 (8HP version) board.
Table D-3: VGA Connector CON5 Pinout
D-sub 15 Signal Function In/Out
1 Red Red video signal output Out
2 Green Green video signal output Out
3 Blue Blue video signal output Out
13 Hsync Horizontal sync. TTL out
14 Vsync Vertical sync. TTL out
12 Sdata Not supported In/Out
15 Sclk Not supported Out
9 VCC Power +5V 200 mA no fuse protection Out
5,6,7,8,10 GND Signal ground --
4,11 Free -- --
$
$
Note:
The 75 Ohm termination resistors for the three VGA signals (red,
green, blue) are located on the baseboard.
1
5
6
11
15
10
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com