Specifications

CP302 Functional Description and Configuration
ID 21112, Rev. 05Page 2 - 16 ® PEP Modular Computers GmbH
2.6.3 VGA Interface
Figure 2-7: D-sub VGA Connector
The CP302 is equipped with the 69030 VGA chip with 4 MB
memory. This contains an SVGA controller that is fully compatible
with the CGA, EGA, Hercules Graphics, MDA, and VGA video
standards. The controller connects directly to the onboard 66 MHz
AGP Interface with a maximum data transfer rate of 266 MB/sec.
The video controller supports pixel resolutions of up to 1600 x 1200
or up to 16.7 M colors. The SVGA controller supports analog VGA
monitors on a 15-pin female D-sub connector, with a maximum
vertical retrace non-interlaced frequency of 85 Hz.
2.6.3.1 VGA Connector CON8 Pinout
The 15-pin female connector CON8 is used to connect a VGA monitor to the CP302
board.
Table 2-6: VGA Connector CON8 Pinout
D-sub 15 Signal Function In/Out
1 Red Red video signal output Out
2 Green Green video signal output Out
3 Blue Blue video signal output Out
13 Hsync Horizontal sync. TTL out
14 Vsync Vertical sync. TTL out
12 Sdata I2C™ data In/Out
15 Sclk I2C™ clock Out
9 VCC Power +5V 200 mA no fuse protection Out
5,6,7,8,10 GND Signal ground --
4,11 Free -- --
1
5
6
11
15
10
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com