Specifications

8
F500 Operation Manual/INTRODUCTION
Using This Manual
INTRODUCTION
Functions Available for Each Controller Model
INTRODUCTION
Functions Available for Each Controller Model
Functions that can be used vary with the controller to which the Application Software is
installed.
For those items, refer to the table given below.
Processing item/Measurement items
The functions that cannot be used are shown for each model.
*1: Run Function Mode
SECTION 3 Test/Measurement Execution
*2: Can be used only if the Application Software has the macro function.
SECTION 1 Basic operating procedures
*3: Can be used if the [+] mark is not attached to the type displayed when [SYS] - [System information] -[Controller] is
selected.
Function
Controller
F210-C10/C15
F210-C10-ETN
F500-C10-ETN
F500-C15-ETN
F250-C50/C55 F270-C10/C15
Non-usable processing items
Input image Items No
Position Compensation Items Circle Position Compensation
Model Position Compensation
No
Measurement Items
Pattern Inspection
Rotation Position
Classification
Density Defect
Inspection
Pattern
Inspection
Rotation Position
Classification
Density Defect
Inspection
Quest Character
Verification
*3
Lot Number
OCV1
*3
OCR for 1
character
*3
No
Measurement Support Items
Branching Control Items
Results Output Items
Results Display Items
No
Run Function Mode *1
Nonstop adjust mode No Yes
Yes
(Select one of the
modes.)
1-line fast mode No
2-line random trigger mode No
Macro Function *2 Yes
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com