Specifications

10
F500 Operation Manual/SECTION 1
Basic operating procedures
SECTION 1
Installing the Application Software
SECTION 1
Executing Installation
This section describes how to install the selected processing items to the Controller.
Before starting installation, select whether to use the macro function. Also select the desired Run
Function mode.
Macro Function p.6, Run Function Mode p.7
1. Select [Install].
A confirmation message will be displayed.
2. Select [Execute].
The size of the processing items will be calculated to
determine if they can be installed.
If the total size of the selected processing items is too
large to be installed, a confirmation message will be
displayed to ask if the files are to be compressed.
Do not turn OFF the power or input a RESET
signal while a message indicating that
processing is in progress is being displayed.
Data in memory will be destroyed, and the
Controller may not operate correctly the next
time it is started.
A confirmation message will be displayed once the
installation has been completed.
If an error message appears:
p.13
3. Press the ENT Key.
Set up
Select items
Install
Backup data load
Clear memory
Option
Selected Programs
will be installed.
The programs and data
stored at present
are cleared.
Execute Cancel
Total size of selected items
is too large to install.
Compressing programs make
the installation possible,
but startup time will
be longer.
Compress programs?
Execute Cancel
p.12
To step 3.
Installation finished.
Put off the memory card
and restart.
OK
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com