Specifications

28
F500 Operation Manual/SECTION 1
Basic operating procedures
SECTION 1
Menu Operations
SECTION 1
Drawing a Region
Use the following method to draw model regions and measurement regions.
The region figures that can be drawn depend on the processing item. Refer to the
explanation for each processing item for information on what figures can be drawn.
 Drawing method
Move the cursor with the Up, Down, Left, and Right Keys. Use these keys together with
the SHIFT Key to move the cursor quickly.
Press the ENT Key at the desired positions.
Press the ESC Key to undo the setting.
Enlarge the image if it is not clear or if you want to draw in detailed areas.
p.29
Measurement
region selection
Drawing method
Box
Ellipse
Circle
Circumference
Polygon
Line
Arc
The whole
region moves.
The lower right
coordinates move.
The figure is set.
ESC Key
ENT Key
ENT Key
The whole
region moves.
The lower right
coordinates move.
The figure is set.
ESC Key
ENT Key
ENT Key
The whole
region moves.
The diameter
changes.
The figure is set.
ESC Key
ENT Key
ENT Key
The whole
region moves.
The circumference
changes.
The width changes.
The figure is set.
ESC Key
ENT Key
ESC Key
ENT Key
ENT Key
Specify the
first point.
Specify the
second point.
Specify the third
and other points.
(Up to 10 points
can be specified.)
The figure is set.
Press the ENT
Key twice.
ESC Key
ENT Key
ESC Key
ENT Key
ENT Key
The whole
region moves.
The length
changes.
The width changes.
The figure is set.
ESC Key
ENT Key
ESC Key
ENT Key
ENT Key
The whole
region moves.
The end
point moves.
The mid-point
moves.
The width
changes.
ESC
The
figure
is set.
ESC Key
ENT Key
ESC Key
ENT Key
ESC Key
ENT Key
ENT Key
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com