Specifications

Control Box Connections to the Reactor Assembly
Control Box Connections to the Reactor Assembly
The control box has connections for the Umbilicus for interface to the Reactor Unit.
These ports are:
Heater Power
- Supplies power to the heaters within each reaction
vessel bank.
Signal - This cable carries thermocouple readings from the Reactor
Unit to the Controller Unit.
Agitation Gas
- Two ports on the Controller unit supply HP gas to the
pneumatic gas cylinder.
Solvent Gas Pressure - A port on the Controller Unit is used to supply
gas pressure to the Solvent Bottle Assembly.
Drain Gas - The drain gas port supplies 30 psi gas line from the
Contoller Unit to the Reactor Unit.
Metered Gas - The drain gas port supplies 10 psi gas line from the
Contoller Unit to the Reactor Unit, and is flow regulated by a needle
valve on the Reactor Unit.
Controller Unit Gas and Power Connections
System Gas
The gas port (located on the rear of the Controller Unit) uses Quick Connect fittings to
interface with a inert house gas system. A minimum of 30 psi is required. (Maximum
pressure
= 40 psi)
Electrical Outlet
The power cord connects to the rear of the Quest Controller Unit. The instrument can
operate on 90-240 VAC wall outlets.
Power Switch
After you have plugged in the power cord to the power outlet, the power switch turns
the power on or off.
QUEST 210 User Manual
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com