Specifications

Temperature Control -
Enter the Temperature Set-Point
On the keypad, press the "Mode" button until the Set Temperature screen is
displayed.
I ---
Set Temperature - -
A: 90C 1:00 OFF
B : lOOC 0.00 OFF
RVSize 5mL 1 OmL
Use the Forward and Back (right and left arrows) buttons to place the cursor over
one of the digits of the setting in the temperature field. Note that there is a separate
temperature field for Side
A and B.
Use the PARAMETER SETTING buttons (up and down arrows) to increase or
decrease the temperature parameter.
Use the Forward and Back buttons to move to the time field. This time will be the
duration at which the reaction vessel bank will stay at the set-point.
Use the PARAMETER SETTING buttons to increase or decrease the chosen time
parameter.
- ---
WARNING As a general rule, do not enter a temperature set point above the boiling
- -
point of the reaction solvent being used. This prevents against over pressurization of the
system.
To start heating for a particular bank, press the STARTISTOP button with the cursor
located on the
LCD line for that bank. The reaction vessel bank will begin to heat
up to the set point. On the initial heat up period, you may see the actual
RV
temperature overshoot the set point by a few degrees, but the system will equilibrate
at the temperature set point.
Set the Upper Manifold Membrane Switch to "Closed." See the next section for
instructions.
If desired, repeat the above steps for the temperature and time parameters of the
other reaction vessel bank.
QUEST 210 User Manual
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com