Specifications

Argonaut Technologies
Revision 06/24/98
-
ASWM Interface
Harness connection
1
Lower Manifold
Pressure connection (port
6)
Figure 3 - ASW Controller Unit Front View
The remaining connection that differentiates the ASW Controller Unit from the standard
Controller Unit is an additional port on the front panel. In figure
3 this port is labeled "Lower
Manifold Pressure connection (Port 6)". Locate the tubing labeled "MEM" in the Reactor Unit
Umbilicus. If the "MEW tubing already has
a ferrule and fitting attached, identical to tubing one
through five, then continue with step
7. If no fitting or ferrule is attached to the "MEM" tubing
continue with step
6.
Slide the fitting (Part Number 100019) on the "MEW tubing with the threads closest to the end
of the tubing. Slide the yellow ferrule (Part Number 100020) onto the tubing so that the smaller
OD is closest to the threads of the fitting. Align the flat edge of the ferrule to the end of the
"MEM" tubing. Create a ferrule swaging tool by screwing the
%-28 plug into the %-28 union
(Part Numbers 100083 and 100200) included with the Automated Solvent Wash Option. Screw
the "MEM" fitting into the ferrule swaging tool. Tighten the fitting finger tight and continue for
?4 turn. Remove the fitting from the swaging tool, you will notice the surface of the ferrule
closest to the fitting will be slightly flattened.
Connect the "MEM" tubing with ferrule and fitting into port 6 on the ASW Controller's front
panel. Make the connection finger tight. Complete the remaining tubing and cable connections
from the Reactor Unit Umbilicus to the ASW Controller Unit. These connections are identical to
the standard Quest and are described in the Quest User Manual.
See Figure 4 for the location of the ports on the front of the ASWM. Connect the BTL PRESS
line from the Reactor Unit Umbilicus to the Bottle Pressure port on the front of the ASWM.
Connect the SOLVENT line from the Reactor Unit umbilicus to the SOLVENT port on the front
of the ASWM. Connect one end of the 0.125 inch OD Teflon tubing with fittings (Part Number
300462) to the VENT port on the front of the ASWM and the other end to the UTILITY 2 port on
top of the Reactor Unit. Use the two hose clamps (Part Number
1 O2559)to hold the vent tubing
tightly to the Umbilicus.
ASWM Interface Harness
d
A B C D Purge
Bottle Pressure
1111 1 0 Vent
\
Solvent
Toggle Valves
Figure 4 - Automated Solvent Wash Module (ASWM) Front Panel
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com