MSDS
MATERIAL SAFETY DATA SHEET
Artisan Metal Restorer
Page 3 of 6
SECTION 7 HANDLING And STORAGE
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING: Protect containers from physical
damage. Store in a cool, well ventilated area away from acids and other incompatible materials.
Prevent eye and skin contact. Do not breathe mists or aerosols. Use only with appropriate protective
equipment. Immediately remove and launder contaminated clothing before re-use. Wash thoroughly
after handling and before eating, drinking, smoking or using toilet facilities.
OTHER PRECAUTIONS: Empty containers retain product residues. Follow all MSDS precautions in
handling empty containers.
SECTION 8 EXPOSURE CONTROLS/PERSONAL PROTECTION
Exposure Guidelines:
RESPIRATORY PROTECTION: Good general ventilation (equivalent to outdoors) should be
adequate under normal conditions. For spray application or areas where the TLV is exceeded, a
NIOSH approved organic vapor or supplied air respirator appropriate for the form and
concentration of the contaminants should be used. Selection of respiratory protection depends
on the contaminant type, form and concentration. Select in accordance with OSHA 1910.134 and
good Industrial Hygiene practice.
VENTILATION: Good general room ventilation (equivalent to outdoors) should be adequate under
normal conditions. If the recommended exposure limit is exceeded increased mechanical ventilation
such as local exhaust may be required.
GLOVES: Rubber, butyl rubber or other impervious gloves are recommended.
PROTECTIVE CLOTHING: Impervious apron, boots and other clothing are recommended if needed
to prevent contact or if splashing is possible.
EYE PROTECTION: Chemical safety goggles and/or face shield should be worn if splashing is
possible. Do not wear contact lenses.
OTHER PROTECTIVE EQUIPMENT: For operations where contact can occur, a safety shower and
an eye wash facility should be available.
INGREDIENTS
CAS#.
EXPOSURE LIMITS
Phosphoric Acid
7664-38-2
1 mg/m3 Ceiling (ACGIH)
3 mg/m3 STEL (ACGIH)
1 mg/m3 TWA (OSHA)
2-Butoxyethanol
111-76-2
50 ppm (skin) TWA OSHA PEL
20 ppm TWA ACGIH TLV
Amorphous Silica fume
69012-64-2
2 mg/m3 TWA ACGIH TLV (respirable
fraction)
Non-hazardous Ingredients
NA
None Established