Use & Care

LEAK TESTING:

GENERAL:

Although all gas connections on your ARTISAN™ Grill are leak tested at the factory prior to shipment, a

complete gas tightness check must be performed at the installation site due to possible mishandling in

shipment, or excessive pressure unknowingly being applied to the unit.

Periodically check the whole system for leaks, or immediately check if the smell of gas is detected.

BEFORE TESTING:

 Make sure that all packing material is removed from the grill.

 Make sure the burner tie-down straps are removed from the unit.

 Do not smoke while leak testing.

 Never leak test with an open flame.

GAS PRESSURE REGULATOR

SUPPLIED BY ARTISAN™ -

MUST BE USED.

TYPICAL ARTISAN™ BARBECUE

(32” MODEL SHOWN)

SHUT OFF HAND VALVE MUST BE

LOCATED IN ACCESSIBLE AREA

INCOMING NG SUPPLY

Figure # 3

NG FLEXIBLE HOSE OR HARD

PIPING BY CUSTOMER

To connect the regulator / hose assembly follow the next steps:

1. Locate the regulator and gas connection point in the rear right side of your barbecue unit (remove

the rear panel from the barbecue cart to gain access - in cart mounted models).

2. Connect the supplied gas pressure regulator to the 1/2” MPT barbecue connection, using either

hard piping or a flexible Ø1/2” gas hose (available from DIY/Home stores) no longer than 48”.