COMPONENTS INCLUDED IN THIS KIT: ITEM DESCRIPTION: QTY: A 1/4-20 x 1/2” SCREW 16 B 1/4” LOCK WASHER 16 ~ PANELS AS SHOWN BELOW 4 A B ITEM NOT INCLUDED AND REQUIRED FOR ASSEMBLY OF THIS UNIT: STANDARD #2 PHILIPS SCREWDRIVER LEFT PANEL REAR PANEL RIGHT PANEL BOTTOM PANEL 2
STEP 1: Assemble your Artisan™ insulated jacket by attaching the LEFT PANEL to the BOTTOM PANEL with 3 screws and 3 lock washers in the lower section of the left panel. TIP: Do not tighten the screws at this time. Leave them loose for easier assembly and fasten all screws as a final step. STEP 2: Continue by attaching the RIGHT PANEL to the BOTTOM PANEL as indicated on step 1. STEP 3: Assemble the BACK PANEL and attach it to the BOTTOM PANEL with 3 screws and 3 lock washers.
STEP 5: Prepare to install your Artisan™ BBQ into the insulated jacket assembly by removing the countertop support ring attached to the firebox of the BBQ. Access these screws by removing the grill cooking grates and setting them aside. 3 SCREWS 3 SCREWS The countertop support ring is attached with 3 screws on each side of the firebox. (See Figure # 2) Save these 6 screws as they will be needed later.
STEP 7: On 32” and 36” Artisan™ BBQ units there is a power cable that is required for the standard light. The cable can be fed through the round hole that is directly below the BBQ electrical box. The large rectangular cutout opening is meant for the fuel connection (NG or LP Fuel). NOTE: Refer to the Artisan™ BBQ manual for the proper fuel connections.
Artisan™ Insulated Jacket Assembly Instructions Artisan™ USA Grills All Rights Reserved • 05/2011 6