Installation Sheet

ManualsBrandsArtisan ManualsGrill AccessoriesInfrared Sear Burner For All Artisan Grills

Artisan

™

USA

INFRARED SEAR BURNER

ITEMS PROVIDED IN THIS KIT MODEL ART-ISB:

Infrared Sear Burner Sear Burner Electrode

INSTALLATION:

WARNING:

Disconnect 110V AC power to the grill before servicing the unit.

(Applies to 32” and 36” units only).

The Infrared Sear Burner for your Artisan™ USA Grill

can be used in any existing grill burner location you

prefer: left, center or right.

•

Remove the grill grate and briquette tray from

the desired location as shown on the right .

(See Figure 1).

•

Lift and remove the U-BURNER out of the grill.

The U-BURNER is simply resting between the

gas valve and the rear bracket located in the

back wall. (See Figure 2)

GRATE

BRIQUETTE

TRAY

Figure 1

U-BURNER

Figure 2

Summary of content (3 pages)

PAGE 1
Artisan™ USA INFRARED SEAR BURNER ITEMS PROVIDED IN THIS KIT MODEL ART-ISB: Infrared Sear Burner Sear Burner Electrode INSTALLATION: WARNING: Disconnect 110V AC power to the grill before servicing the unit. (Applies to 32” and 36” units only). The Infrared Sear Burner for your Artisan™ USA Grill can be used in any existing grill burner location you prefer: left, center or right. • GRATE Remove the grill grate and briquette tray from the desired location as shown on the right . (See Figure 1).
PAGE 2
• Using a screwdriver, remove the electrode screw and pull the U-BURNER electrode out SLOWLY. SCREW There is additional ignition wire located inside the front of the grill in order to pull the connector approximately 1” outside of the front wall. (See Figure 3) • Remove the electrical wire connected to the back of the U-BURNER Electrode by gently pulling and moving from side to side. U-BURNER ELECTRODE DO NOT let go of this wire as you will need to reconnect it to the SEAR BURNER Electrode.
PAGE 3
• Verify that SEAR BURNER is properly seated on the back support bracket. The burner should rest on both legs of the bracket and it should be leveled with the front. (See Figures 6 and 7) BACK BRACKET Figure 6 Figure 7 • DO NOT install the briquette tray on top of the SEAR BURNER as it will damage the briquette tray and the SEAR BURNER and this damage is not covered under warranty. • Reinstall the grill grate on top of the SEAR BURNER and you are ready to grill.