Manual and User Guide

13
PUSH TO
IGNITE
PUSH & TURN TO “HI”
Keep your face away from the grill as far as possible and pass a lit,
long stem match through the notch in the grill rack to the ports of
the burner you are trying to light. When attempting to light a burner
with a match, ensure that the correct burner control knob is used.
Position the match near the burner ports. Push and turn the control
knob to “HI”. Repeat procedure on each burner if necessary. If the
burner does not light in 4 seconds turn the knob OFF, wait 5
minutes and try again. If the burner will not light after several
attempts see page 25: Troubleshooting.
To assure that an IR burner is lit, very carefully
place your hand 8-10 inches away from the
burner surface. If you do not feel the heat of
the burner, shut off control knob, wait five
minutes, and attempt to relight.
BUTTON SYMBOLS AND LOCATIONS:
IGNITER BUTTON SWITCH
(on RIGHT side)
LIGHT FIXTURES SWITCH
(on RIGHT side)
CAUTION
IN SUNNY ENVIRONMENTS,
THE FLAME FROM AN IR
BURNER MAY BE IMPOSSIBLE
TO SEE.
ROTISSERIE INSTALLATION:
ROTISSERIE KIT:
26” ART-ROT 26 (OPTIONAL).
32” ART-ROT 32 (INCLUDED).
36” ART-ROT 36 (INCLUDED).
ATTACH ROTISSERIE MOTOR TO
EITHER END USING THE HARDWARE
PROVIDED