Owner`s manual
4. Carefully line the grill pins up with the grill cups
on
the
LCR.
Using
even
pressure press
the grill into place.
DO
OT
press
on
the center
of
the grill surface; apply pressure only at
the corners.
Wiring
the
lCR
left
and Right front Channel Speakers
1.
A channel
to
run your wires is located on the inside
of
the
Tower
as
well
as
an
area
to
attach wire ties for a clean installation. Remember that
you
must run the parallel wire
to
the side where
you
are
connecting the Center Channel.
2. Hook up the left and right channels the same
as
any other
speaker.
Connect one
end
of
the left front channel speaker wire
to
the left front channel terminals
of
the receiver /
amplifier. Connect the positive wire
to
the positive terminal
on
the
receiver,
and the
negative wire
to
the negative terminal. Then connect the other
end
of
the left speaker wire,
positive and negative,
to
the positive and negative terminals located
in
the input terminal
on
the
back
of
the
speaker.
Repeat
this procedure for the right channel speaker
wire.
Note:
If
necessary, strip the insulation from each
of
the speaker wire ends approximately
1/2"
and
twist
the strands
of
wire
at
each
of
the
individual
wire ends
tightly
together. This
makes
connecting
the
wire
easier and prevents
short
circuits to adjacent wires
or
ter-
minals.
Wiring the lCR Center Channel Speakers
1.
Using wire ties and the supplied wire tie loops, strap the wires
to
the tower for a clean
appearance.
Leave
the wire ties loose
to
allow
you
to
add
the center channel wire
in
the
next step.
2.
Connect one
end
of
the center channel speaker wire, positive
and
negative, to the positive
and negative center channel terminals
of
the receiver/amplifier. Connect the other end of
the center channel speaker wire
to
the center channel input terminals
in
the cup
on
one
of
the
LCR
speakers -
you
may
connect the wire
to
either
of
the center channel speakers.
3.
Use
the supplied jumper
wire,
or
another wire
of
your choice,
to
connect the two center
channel speakers in parallel,
be
sure
to
route the wire through the wire channel. Your
wiring
through the channel should
look
like
Diagram 10
(Right
/ Center Channel
with
wire
for
amplifier
and parallel
jumper
wire
shown)
12