Owner`s manual

7. After you have hooked up your speaker to your receiver or amplifier, remove the grill and
aim the Center Channel (top speaker) at the opposite listening position. This means that
the right center should
be pointed towards the left listening area and the left center
should
be pointed towards the right listening area. Try slight variations in the angle
of each tower to give you a good center image across the listening plane. Please Refer
To Diagram 12
Diagram 12
Attaching the Grilles
8. Attach the grilles by aligning the top of the grille with the top of the speaker and press
the grille's pins into the small cups on the front of the speaker. Note: The grille can fit
tight when the system is new so it may be necessary to hold the speakers from the
rear while pressing the grilles into place.
Setting Up The Receiver
9. The DOLBY HIGH PASS SmlNG in most receivers is 80Hz when set in the SMALL
SPEAKER position. The LCR Front speakers and the LRS Surround speakers have been
optimized for this setting. The receiver should be set so that the main speakers operate in
this mode. This will provide
the dynamics needed for movies and will allow the system to
be played at high levels with very low distortion.
14