Owner`s manual
LRS
Surround
Satellites
(Left,
Right,
Surround)
Unpacking
the
LRS's
1.
Remove
the top portion
of
foam protecting the
LRS
Surround Speakers.
2.
Carefully
lift
the Surround out
of
the packing.
a.
When
lifting the
LRS
be
careful not
to
touch the drivers.
3.
Remove
them from the protective plastic
bag.
4.
Place
the speaker
on
its
back.
the large flat surface.
5.
When looking at the
face
of
the speakers
you
will
see
four screw holes located at the outer
corners, these attach the front
of
the speakers
to
the wall mount plate.
6.
Using
the
supplied Metric #3 Allen Wrench, remove the four screws that hold the wall
mount Bracket
to
the speaker
by
turning the screws in a counter-clockwise direction.
7.
Lift
the
speaker
off
of
the
wall mount
bracket
and
set
the
speaker
aside.
Refer
to
Diagram
13
e:>
/
Bracket
Screws
\
Diagram
13
Mounting
the
Speaker Bracket
9.
Determine the best location for mounting the speakers.
a.
They should
be
positioned approximately 70% up the wall.
So
for ceiling height
of
10;'
the
speaker should
be
about 7' from the floor. This
is
only
an
approximate dimension;
your room layout will determine the final height the speaker will
be
mounted.
b.
The
LRS
should
be
located directly next
to,
or behind the primary seating
area.
Try
not
to
mount them in front
of
the primary seating location
as
this
is
not optimal.
c.
Find a location that will not
be
blocked
by
objects, such
as
a plant or mounting the
speaker
too
close
to
a corner.
d.
Keep
the speaker at least two feet
away
from any corner.
e.
When using the Surrounds
as
rear speakers they should
be
located approximately the
same distance apart
as
the front channels and should
be
at the same height
as
the
Side Surrounds.
15