Owner`s manual
•
•
•
-\
Port
Diagram 15
11.
Place
the bracket against the wall at the desired mounting location.
a.
Line the bracket mounting holes up
on
a stud where possible. Of
you
can
not attach
to
a stud follow the instructions for using dry wall anchors in
Diagram
14.
b.
Use
a level
to
make sure that the speaker is level once
it
is
mounted.
12. Using a pencil, mark the mounting locations
on
the wall
by
drawing through the mounting
holes
in
the bracket.
13.
Set the bracket aside.
14.
If
you
were
not able
to
mount the
LRS
to
a stud,
use
dry wall inserts. Using drywall
anchors create secure mounting locations for the speaker bracket.
a.
This should
be
done with
any
screw locations that
DO
NOT
hit
wall studs.
b.
Use
anchors that will hold at least two times the weight
of
the
speaker.
15.
Now mount the wall bracket.
a.
Pull the speaker wire through the rectangular opening
on
the bracket.
b.
The
rectangular opening
in
which the wires
are
pulled through should
be
at the
bottom
of
the bracket.
c.
Mount the bracket
to
the wall using drywall screws and
lor
the screws for anchors that
you
installed earlier.
(DO
NOT
OVER
TIGHTEN THE
SCREWS
AS
THIS WILL
WARP
THE BRACKET
AND
MAKETHE
LRS
INSTALLATION
DiffICULT)
d.
Use
at least 11j4" course thread drywall screws anywhere that
you
are
mounting
to
a
stud, this will insure that the bracket
is
held securely.
17