Owner`s manual
Wiring and
Mounting
the
LRS
Speakers
16.
Carefully
lift
the speaker into position.
17.
Wire the left and right channels the same
as
any other surround speaker. Connect the left
positive and negative
of
one end
of
the wire
to
the receiver / amplifier. Connect the left
positive and negative
to
the speaker terminals located on the rear
of
the speaker.
18.
When connecting the speaker wire
to
your
LRS
make sure that the positive and negative
terminals
are
correctly attached
to
the positive and negative
of
the speaker wire.
19.
Strip the ends
of
the speaker wire approximately Vi' and twist the wires tightly.
20. Connect the wire
to
the rear
of
the
LRS
by pressing
on
the speaker terminal; this will open
a hole
on
the side
of
the terminal. Slip the end
of
the stripped wire into this hole and
release the terminal. The terminal should now securely hold the wire in place.
21.
While placing the speaker into position
be
sure that the wires do not get pinched between
the bracket and the
speaker.
22. Using the four screws that
you
removed in step
#6
remount the speaker
to
the
mounting bracket.
a.
Insert the screws and tighten
by
turning
in
a clockwise direction.
b.
Be
careful
to
not over tighten the screws.
Attaching the Grills
23.
Remove
the grill from the plastic
bag.
24. Attach the grills
by
lining the side
of
the grill with the
one
side
of
the speaker and partially
insert into the grill slot.
25.
You
can
use
SLIGHT pressure
if
necessary
to
"squeeze" while fitting
it
into the grill slot
on
the opposite side
of
the
speaker.
The
grills will spring
back
into shape creating a pressure fit.
Refer
to Diagram 16
Diagram 16
Setting
up
the Receiver
The Dolby High
Pass
Setting in most receivers
is
80Hz when set
in
the SMALL speaker position.
We
have
optimized the
LRS
Surround Channels for this setting. The receiver should
be
set
so
that the main speakers operate
in
this mode. This will provide the dynamics needed for movies
and will allow the system
to
be
played at loud levels with very low distortion. '
18