Owner`s manual

Important
The outer edge of each bracket should be flush with the outside edge of the display.
The ribbed portion
of a bracket can extend beyond the side surface of the display - the
exact position will
vary from display to display. When the brackets are installed properly,
the ribs
on the sides of the brackets are dimpled out and away from the set.
Tighten the
screws using the appropriate Allen or Socket Wrench, depending on the plasma
model. Tighten
the screws until they are snug. Caution: DO NOT over tighten the
screws or
you risk damage to the display.
Diagram 2
6. Remount the display
on its bracket Dr stand.
7. Make sure that the display is secure and will not fall or tip over before proceeding.
8. Carefully remove your Portrait
LCR speakers from their packing.
9.
Remove the protective foam from between each speaker and its Main Bracket and place
the
LCRs on their large, flat sides. WARNING: DO NOT place the speakers on their faces
as this may permanently damage the drivers.
4