Owner`s manual
10.
Remove
the Main Bracket mounting knobs
by
twisting them
in
a counter-clockwise direction.
11.
Carefully slip the Bracket
off
of
the
LCR.
Refer
to
Diagram 3
Diagram
3
12. Locate the center
point
between the top and bottom
on
each
side
of
the display and place
a short piece
of
masking tape there. Then using a tape measure, determine the exact
vertical center
of
the display and make a mark
on
the tape with a
pen
or pencil. Double-
check your measurements.
13. Place the
LCR
Main Bracket against the Televison Brackets that
you
previously attached
to
the display. Make sure that the grooves
on
the Televison Bracket and the Main Bracket
fit
into one another.
14. Insert the supplied screws
to
loosely hold the Main Bracket
in
place, do not tighten them
yet
• There
are
additional screws included in
each
grill
kit
to
account for loss.
It
takes only 2
screws per side (One at the top and one at the bottom)
to
secure the television brackets
and the Main brackets together. The spare holes in the television bracket
are
to
allow for
different models
of
televisions
15.
Slide the Main Bracket until its center mark
(a
slight indentation) lines up with the center
mark that
you
made earlier
on
the masking tape and tighten the
screws.
Refer
to
Diagram 4
5