Owner`s manual
Wiring
the
LCR
Left and Right Front Channel Speakers
19.
Wire
the
left and right channels the same
as
any other
speaker.
Connect one end
of
the left
front channel speaker wire
to
the left front channel terminals
of
the receiver/amplifier.
Connect the positive wire
to
the positive terminal
on
the
receiver,
and the negative wire
to
the negative terminal. Then connect the other end
of
the left speaker wire, positive and
negative, to the positive and negative terminals located
in
the cup
on
the rear
of
the
speaker.
Repeat this proced
ure
for the right
cha
nnel speaker
wi
reo
Note:
If
necessary,
strip
the
insulation
from
each
of
the speaker wires ends
approximately
112"
and
twist
the
strands
of
wire
at
each
of
the
individual
wire
ends
tightly
together.
This
makes
connecting
the
wire
easier
and
prevents
short
circuits
to
adjacent
wires
or
terminals.
20. Connect the wires to the terminals
of
the
LCRs
by
pressing
on
the top
of
the speaker
terminals; this will open a hole in the side
of
the terminal. Slip the bare end
of
the
stripped wire into this hole and release the terminal. The terminal should now securely
hold the
wi
re
in
place.
Wiring
the
LCR
Center Channel Speakers
21.
Connect one
end
of
the center channel speaker wire, positive and negative, to the positive
and
negative center channel terminals
of
the receiver/amplifier. Connect
the
other
end
of the
center
channel
speaker
wire
to
the
center
channel
input terminal
cup
on
one
of
the
LCR
speakers
-
you
may
connect the wire
to
either
of
the center channel
speakers.
22.
Use
the supplied jumper wire
(red
and
black wire), or another wire of your choice,
to
connect
the two center channel speakers
in
parallel.
•
Remove
and twist the supplied
jumper
cable together with the wire that
is
attached to
the center channel
input
and re-insert.
Be
sure that there
are
no
strands
of
wire that
could short out the positive and negative leads.
• Connect the other end
of
the wire
to
the center channel input that has
not
already been
hooked up to the
receiver.
Make
sure that positive
is
connected
to
positive and negative
is
connected to negative for all connections.
Your wiring
is
now complete and should look like the illustration
in
Diagram 6.
Right
Center
Stage
Tweeter
Right
Channel
(-I
1+1
1+1
(-I
Right
Amplifier
Top
Rear
3.1
/5.1
Channel Set Up
Center
(-)
1+1
Left
Left
Center
Stage
Tweeter
Left
Channel
Diagram 6
Note:
'''The
portrait
system may also be wired
in
a stereo
configuration
as
in
Diagram
6A
7