Owner`s manual
Right
Center
Stage
Tweeter
Right
Channel
Right
Top
Rear
Stereo Set-Up
+)
•
Amplifier L
-..J~~~==
1+1
Left
Left
Center
Stage
Tweeter
Left
Channel
Diagram6A
Attaching
The Grilles
23. Attach the grilles
by
aligning the top
of
the grille with the top
of
the
display and pressing
the grille's pins into the small cups
on
the front
of
the speaker. Note: The grilles
can
fit
tight
when the system
is
new,
it
may
be
necessary
to
hold the speakers from the back
while pressing the grilles into place.
Setting
Up The Receiver
24.
The DOLBY HIGH
PASS
SETIING in most receivers is 80Hz when set in the SMALL
SPEAKER
position.
We
have
optimized both the
LCR
Front speakers and the
LRS
Surround
speakers for this setting. The receiver should
be
set
so
that the main speakers operate in
this mode. This will provide the dynamics needed for movies and will allow the system
to
be
played at high levels with very low distortion.
Adjusting
The Settings On The
LCR
Speakers
There are two switches
on
each
LCR
speaker which allow
you
to
adjust the acoustics. One
switch for the Left / Right Channel Stage Tweeter and the other for the Center Channel
Presence Control. Both switches
are
located
on
their respective input terminal cups
on
the
back
of
each
LCR.
Stage Tweeter Settings
Turning on the Stage Tweeter widens the sound stage. The decision
to
use the Stage Tweeter
is
dependant
on
individual taste and on the particular installation.
25.
Adjusting the Stage Tweeter
• The switch turns the tweeter
on
and off. In most installations, the Stage Tweeter should
be left
on
.
• Since
it
is difficult
to
see
the markings when the system
is
mounted,
you
can
tell that
the switch
is
in the
on
position
by
feel. When the switch
is
set towards the outside
of
the
system (away from the display)
it
is in the
on
position.
8