Instructions / Assembly

BASE
SCREW(A)
ADAPTOR
ASSEMBLY INSTRUCTIONS
NOTE:
Before assembling your new lamp,please read the following precautions and
instructions thoroughly.
IMPORTANT SAFETY INSTRUCTIONS
The electrical wire is connected continuously through the poles.Do not pull wires
during
unpacking,bad connections may result. Place the lamp indoor dry area only.
1.Carefully unpack all parts from the packaging and place them on a flat/smooth
surface like carpet.Be sure to remove all the packaging materials from the lamp.
*Do not plug into the electrical outlet when installing.
4.Screw tightly the above steps with the
A
ll
e
n W
re
n
c
h
5.Connect the Male and female
Co
n
nec
tor
.
7.Insert the
5 A
rc
h
Pipe
into the
S
te
el P
i
pe
and Secure it with the
S
cre
w
B
.
8.Connect the adapter
and plug into the wall outlet,your lamp is ready to use.
For customer service,please email:
[e-mail] or visit us at
www.artivausa.com.
We will respond within 24 hrs Monday-Friday 9am to 5pm PST(except Holiday)
5 ARCH PIPE
STEEL PIPE
SCREW(B)
CONNECTOR
ITEM
#
:
L
E
D
8
0
2
2
6
8
FC
LED
802
268
SN
ALLEN WRENCH
WASHER
DIMMER BUTTON
1
2
5
3
4
6
7
8
9
10
11
9.Touch and hold the dimmer button to adjust the brightness.
SCREWDRIVER
PRODUCT SPECIFICATION:
LED Max:25W(5
×
5W)
Light Switch:Touch dimmer Color Temperature:3000K
2.Unscrew the pre-installed the two washers and nut from the bottom of the pipe.
6.Unscrew the pre-installed Screw(B) from the bottom of the Arch Pipe.
(Pre-installed)
NUT
to ensure stability and avoid tip-over.
3.Insert the Steel Pipe with Screw(A)
into Base,secure with Washers and Nut.