Instructions / Assembly

A
A
B
C
(included)
F
E
F
E
TABLE LAMP
ITEM#:LED9938TAB&LED9938TJB
ASSEMBLY INSTRUCTIONS
NOTE:The electrical wire is connected continuously through the poles. Do not pull
wires during unpacking. Bad connections may result.
1) Use hex wrench (E) tighten screws(F) to lock swing arm connectors.
Please note: Do not over tighten the screws(F), tighten it until the screw is on
the same level as the metal surface. (Two extra screws(F) are included)
2) Put the LED bulb(C) (included) within the lamp holder
3) Use handles(A) to adjust height
For customer service,please email:[e-mail] or
visit us at www.artivausa.com.We will response within 24 hrs
Monday-Friday 9am to 5pm PST(except Holiday)
D
WARNING:
For your long lasting uses,please use Artiva approved LED Bulbs only.
Lightbulb item# L3-8TDM-E26-30.
Other brand may not be compatible to Artiva LED lamp, it may cause the dimmer
switch to burn out quickly,therefore void the manufacture warranty that comes
with this lamp.
Please note:
Do not over tighten the screws(F),
tighten it until the screw is on
the same level as the metal
surface.