MC 250 PROFESSIONAL PROJECTOR User's Guide 2838 Vicksburg Lane North Plymouth, MN 55447-1878 USA Tel: 888.975.9555 Email: info@artograph.com Plug into your creativity at www.artograph.
SAVE THESE INSTRUCTIONS Thank You... for purchasing an Artograph MC 250 projector. This projector has been designed with superb optics and projection characteristics, producing outstanding image quality and accuracy. The MC 250 will enlarge any image from photos to complex designs in full color and with infinite detail. Use it to view or trace photos and designs onto a wall, canvas or any vertical surface with outstanding results.
Loading Copy (Figs. 2-6) 1 2 3 Raise the copy cover and place copy face down onto the glass surface, close the cover. To project oversize copy or books, the copy cover is removable. When removing the cover, however, it is necessary to ensure that the micro-switch is depressed to power on the lamp. The micro-switch is located on the top surface of the copy area. Turn On Power (Fig. 1) The power rocker switch is located on the lower backside of the unit.
Focus (Fig. 8) Rotate the lens to sharpen the image. When focusing extends the lens out of the projector, pull out the lens support that is positioned underneath the lens. 8 ILLUMINATION The MC 250 is equipped with a special 300-watt Tungsten-Halogen lamp that is only available from Artograph or an Artograph dealer. In addition, the MC 250 is equipped with a fuse designed to protect the electrical system against bulb failure. When the lamp blows usually the fuse does too. Replacement lamp includes a fuse.
Insert a new Halogen lamp into the lamp slider. DO NOT TOUCH THE LAMP WITH YOUR BARE FINGERS! Oil from your fingers reduces the lamp life. Move the lamp slider with the lamp to the right until it stops. The lamp is now inserted into the lamp socket. Replace the heat protection filter and the top glass. Pilot Lamp Replacement (Fig. 13) The pilot lamp is located in a compartment on the bottom side of the unit. Move the cover of the compartment in direction of the arrow.
WARRANTY ARTOGRAPH projectors are warranted to be free from defects in material and workmanship for ONE YEAR from the date of purchase by the consumer. Any part to the equipment found to be defective under normal installation and use during the warranty period will be repaired or replaced by ARTOGRAPH. The equipment should be returned, postage or freight prepaid, to ARTOGRAPH and must be accompanied by a proof of purchase. CONTACT OUR OFFICE, PRIOR TO RETURNING, FOR RETURN AUTHORIZATION.
