Manualshelf

User's Manual

ManualsBrandsArts Digital Technology ManualsElectronicsBluetooth Karaoke System w/7 Inch TFT
11121314151617181920
MAKING THE CONNECTIONS
CD OR CD+G / MP3+G OPERATION
SETTING UP YOUR MICROPHONE
1. Plug a microphone into the MIC1
or MIC2 jack at the rear of your
Karaoke Machine. Their output is
mixed with playback from
CD/CD+G.
2. Located on the microphone,
there is an ON/OFF switch.
3. Ensure you set the ON/OFF
switch on the microphone to ON
when required for use.
This unit is designed to play CDs/CD+G/MP3/MP3+G
disc bearing the identification logo respectively. If the
disc does not conform to the standard, it may not play
properly.
NOTE: The unit may not be able to read CDR or CDRW disc correctly. The readability
depends on the quality of recording produced by CD recorder or CD writer.
LOADING A DISC
1. Pull the CD door on the front from the position close to the CD
Door Open Area. Place a disc in the CD compartment with the
printed side facing toward you.
2. Gently close the CD Door to the CD compartment. The Karaoke
Machine begins to read the disc and “READ” will be displayed.
After that, the operation icon will appear on the top of the TFT
screen.
3. Press PLAY/PAUSE to play the disc. (If no disc is loaded, it will
display “NO DISC”)
Warning:
Please do not point the microphone head directly to the front of the speaker(s) on the unit
when you are singing, it would cause unwanted feedback sound that may affect the
performance of your unit.
Tapping or dropping the microphone while it is on can permanently damage your
microphone. Resist the urge to swing the microphone around by the cord!
VHF wireless microphones are not recommended to work with this Karaoke system. Some
VHF wireless microphones may cause unwanted noise and interference.
EN - 11
TURNING POWER ON/OFF
1. To turn on the Karaoke Machine, press the STANDBY button
once, the POWER indicator will light up to full brightness and TFT
2. To turn off the system, press the STANDBY button again. The
power indicator will light to half brightness and TFT screen will turn
screen will display the OPENING SCREEN and start to read CD.
(If no disc is loaded, it will display “NO DISC”)
off.