User Guide

ARTS PDF Split Pro™ Guide
Appendix A - Rectangle Commands
ProvideBaseFilename
Takes the specified string parameter entered and uses it as the base filename of any split output
files.
ProvideFilename
Whatever text falls inside the rectangle (see runs of text) is used as the file name for the fragment.
If this command appears more than once in the coordinate file, the last provideFilename command
will overwrite any other provideFilename commands.
ProvideFilenameIfStringInBox
The text inside the rectangle on a page is searched for the specified parameter. If the string
parameter is found inside the rectangle, then all the text inside the rectangle box on the first page
of the split output file is used as the output filename
ProvideFilenameFromFirstWord
The first word of the text inside the rectangle (or start of the text run) is appended to the output
filename. Any initial spaces are skipped, and the word continues until a space or the end of the run
of text.
ProvideFilenameFromSelectedWord
This looks at the text inside the rectangle and takes the word of text determined by the value
specified. The word is appended to the output filename.
ProvideFilenameFromRangeOfCharacters
This looks at the text inside the rectangle and takes a range of characters from that text and
appends the characters to the output filename. The range of characters is specified by two values,
firstNum and lastNum.
ProvideFilenameAfterString
This is similar to the providefilename command, except that the software searches the text inside
the rectangle for string, and if it finds the string, only the text inside the rectangle that comes after
string is used for the file name. If string is not found, nothing is appended to the file name.
ProvideFilenameAfterStringInBox
The text inside the rectangle on a page is searched for the specified parameter. If the string
parameter is found inside the rectangle, then the text after the string parameter and inside the
rectangle box on the first page of the split output file is used as the output filename.
AddToFilename
This command adds the string parameter to the output filename.
addToFilenameTextInBox
This command adds all text inside the rectangle box to the output filename.
addToFilenameIfStringInBox
This searches inside the rectangle for the string parameter. If the string parameter is found, it adds
the text within the rectangle box to the output filename.
| CONTENTS |  Page 47 of 58 