User`s manual

50 ARTURIA – Analog Lab – USER’S MANUAL
5.4.5 Preset details
To the right of the Preset list is a window showing essential details about the selected
Preset. You can edit any of the details from this window except the name of the preset;
that operation is accomplished using the Save As procedure. (The Synth instrument type
is fixed, of course.)
Preset details
An image of the instrument on which the preset is based is shown along with the
following information:
Name
The name of the current preset (to rename, use Save As button)
Synth
The name of the virtual instrument
LFO Sync
Toggle MIDI sync of LFOs on or off
Polyphony
The number of available voices for the current preset
Key Mode
Choose Mono, Unison or Poly modes for the polyphony setting
Seq/Arp Step Size
Subdivide or multiply the note value of an active sequence or
arpeggio, or adjust its speed if LFO Sync is not enabled
Pitchbend Range
Set the maximum limits of the pitch bend wheel
Note: If the preset for which you are adjusting the details is a Factory preset, you must
save this preset as a User program in order to recall those changes later.
5.4.6 Editing a preset
One of the great features of Analog Lab is that it is possible for any of its presets to be
opened and edited using the original Arturia soft-synth on which it was created, as long
as you have purchased and installed a copy of that synthesizer on your computer.
That being the case, then clicking on the picture of that synthesizer inside the Preset
details window will open the current preset inside that synth.