User`s manual

ARTURIA – MiniLab – USER’S MANUAL 23
4.4.2.2 Settings for the Pads
Settings that are available for each of the pads are:
MMC
Set the CC number value to the same number to configure the
pad to send the following MIDI Machine Control commands:
01 Stop
02 Start
04 Fast forward
05 Rewind
06 Record
Switched
Toggle: With each press of the pad a value will be sent for the
selected CC number: first the Max/LSB number and then the
Min/MSB number, and so on.
Gate: When the pad is pressed it will send the Max/MSB value
for the selected CC number, and when released the Min/LSB
value will be sent.
MIDI Note
Toggle: With each press of the pad a Note On or Note Off
message will be sent for the selected MIDI Note number: the first
press will play the note at the velocity specified by the Max/MSB
value; the second press will send a Note Off message at the
velocity specified by the Min/LSB value.
Gate: When the pad is pressed it will play the note at the
velocity specified by the Max value; releasing the pad will send a
Note Off message at the velocity specified by the Min value.
Patch Chg
Use the CC number field to select the Program Change number.
MSB and LSB are used to specify the Bank Select message that
may be expected by the receiving device
Min / LSB
and
Max / MSB
Depending on the settings of the other parameters, these fields
will serve one of the following functions:
 Define a minimum / maximum range for a standard MIDI
Continuous Controller setting (switch-type or variable).
MSB/LSB are not used in this case.
 Define the velocity values for Note On and Note Off
messages. Note On velocity is set by the Max value; Note
Off velocity is set by the Min value. MSB/LSB are not used
in this case.
 Define the Bank Select message to be sent with a Patch
Change. Min/Max are not used in this case.