User`s manual

ARTURIA – MiniLab – USER’S MANUAL 25
4.4.2.5 Settings for the Pedal
To access the pedal control, click on the image of the pedal jack on the left panel, just
above the image of the USB connector. Settings that are available for the pedal are:
Switched
Toggle: With each press of the pedal a value will be sent for the
selected CC number: first the Max/LSB number and then the
Min/MSB number, and so on.
Gate: When the pedal is pressed it will send the Max/MSB value
for the selected CC number, and when released the Min/LSB
value will be sent.
MIDI Note
Toggle: With each press of the pedal a Note On or Note Off
message will be sent for the selected MIDI Note number: the first
press will play the note at the velocity specified by the Max/MSB
value; the second press will send a Note Off message at the
velocity specified by the Min/LSB value.
Gate: When the pedal is pressed it will play the note at the
velocity specified by the Max value; releasing the pad will send a
Note Off message at the velocity specified by the Min value.
4.4.3 Send your settings to the keyboard
Changes made inside the MIDI Control Center are actually not stored inside the MiniLab
until you press the “Send to Keyboard” button. If you don’t do this important step then
the MiniLab will not be able to recall the changes to you made to any of the controls’
functions if a different preset is loaded.
So once you have everything the way you want, select one of the eight memory
locations by clicking on the “to Mem” menu:
Please note: This procedure will overwrite whatever is in the targeted memory location
on the MiniLab, so be sure you’ve chosen the right destination. Once you’re sure, press
“Send to Keyboard” and it’ll be there the next time you fire up the MiniLab.
4.4.4 Restoring the default values
Clicking the Default Values button will initialize the settings for every control and reset the Global settings
to their factory default values! If there are control settings you don’t want to lose, be sure you have saved
them to your computer and/or one of the memory locations of your MiniLab before you click this button.