User`s manual

32 ARTURIA – MiniLab – USER’S MANUAL
The first press of Pad 6 will send a CC# 74 command with a value of 78, which will close
the filter down part way but still let a lot of the audio pass through. The second press of
Pad 6 will send a value of 127, opening the filter completely.
Note: Be sure to check the MIDI Channel assignment to make sure it matches that of the
receiving device.
5.1.5 Assign an Encoder to control a MIDI CC # between two values
The encoders are assignable using the same techniques described for the pads. Let’s
give a quick example of an interesting use: setting the rate of an LFO so it operates only
within a certain range.
Looking at the picture above we see familiar information:
 Encoder 5 has been selected, so it is shown in red.
 It is assigned to the Global MIDI channel; you can specify any MIDI channel from
1-16 or leave it on the Global channel.
 Its Mode is set to Continuous, which means it will transmit a MIDI Continuous
Controller number when it is turned.
 The second Mode field is set to Absolute, which means it will transmit in a linear
fashion from fully counter-clockwise to fully clockwise.
 The CC number field shows CC# 76, the MIDI CC # that has been assigned to
control Vibrato Rate.