User Manual

ARTURIA – ARP 2600 V – USER MANUAL 54
4 “Mix” switches: This switch allows you to merge one or several inputs pairs into
the one above.
4 “Volume” potentiometers: Potentiometer to set the volume of 2 input signals
(A and B for example)
4.1.8 Sample and Hold generator
This module lets you sample the signal connected as input. The source can be
external (source of trigger connected to the input) or pre-cabled to the noise
generator. This module allows you to create random modulations by sampling
the noise signal, for example.
You can also connect an external clock source to pilot the sample and hold
speed (the waveform output of an oscillator for example).
The sample and hold settings
Level (Level): Sets the Sample & Hold modulation level.
Rate (Rate): Sets the Sample & Hold clock speed.
External Input (“Noise gen”) : Audio or modulation external signal input
connection jack. (pre-cabled to the noise module)
Sample and Hold output: Sample and Hold output connection jack
Internal clock output (Int Clock out): Sample and Hold internal clock
output connection jack
External clock input (Ext Clock in): External clock input connection jack
MIDI Synchronization (MIDI sync): Selector switch for the synchronization of the
clock to a MIDI sequencer.
4.1.9 The “electronic switch” module (Electronic switch)
The “Electronic switch” module allows you to alternate the two sources
connected to inputs A and B depending on the speed of the clock connected