User Manual

74 ARTURIA – Analog Laboratory – USER’S MANUAL
The Sequencer transport section
7.1.8 Synthesis section
This part presents all the synthesis parameters for Analog Laboratory. As mentioned in
the beginning of this chapter, more ample information can be found in the corresponding
section of the manual.
7.1.8.1 Kbd switch
These two buttons are used in the Scene mode. The Scene mode allows use of 2 presets
that can each be controlled from the keyboard using the Control knobs and Envelope
faders:
When the Upper button is selected, all of the knobs and faders in the Control and
Envelope sections will control the Upper preset of the Scene.
If Lower is selected, then control information on the keyboard from the Control and
Envelope knobs and faders will be sent to the Lower preset of the current Scene.
7.1.8.2 Filter
There are two rotary encoders available to alter the filter settings of the selected preset.
These two encoders are “Cutoff” and “Resonance”.
Filter encoders
7.1.8.3 LFO
There are two rotary encoders available to alter the LFO settings of the selected preset.
These two encoders are “Rate” and “Amount” that will set the speed of the LFO and how
much is used, respectively.
LFO encoders