User Manual
Table Of Contents
- User Manual
- Special Thanks
- Thank you for purchasing KeyLab mkII!
- Special Message Section
- Introduction
- Table Of Contents
- Getting Started
- Overview
- Analog Lab mode
- DAW mode
- User mode
- Chord mode
- CV / Gate / Mod connections
- MIDI Control Center
- Connecting to MIDI Control Center
- MCC Controller Map
- Customize the Wheels
- Select the User Channel
- Customize the Pads
- Customize the User buttons
- Customize the Encoders
- Customize the Faders
- Customize the Select buttons
- Customize the Keyboard
- Customize the CV Modulation Input
- Customize the Pedals
- Customize the Pitch Out
- Customize the Gate Out
- Customize the Mod 1 / Mod 2 outputs
- The Device Settings tab
- Import and Export buttons
- Software License Agreement
- Declaration of Conformity
3.2. Part / Live selection
There are 3 control buttons located to the left of the encoders, faders, and Filter buttons.
(They are bracketed in red in the graphic above.) In Analog Lab mode the blue text above
the control buttons reveals their purpose:
• Part 1: Select the controls for the current single instrument or for Part 1 of the
current Multi
• Part 2: Select the controls for Part 2 of the current Multi, or add a second layer
[p.30] to a single preset
• Live: Select the controls for the Macro parameters, Part volume/panning, and
Send A / B controls of the current Multi. If the Live button is held and a key is
pressed, Split mode [p.30] will be enabled.
♪: Macros are created within Analog Lab 3. To learn more about Macros and Multis, please consult
the Analog Lab 3 user manual.
25 Arturia - User Manual KeyLab MkII - Analog Lab mode