User Manual
Table Of Contents
- User Manual
- Special Thanks
- Thank you for purchasing KeyLab mkII!
- Special Message Section
- Introduction
- Table Of Contents
- Getting Started
- Overview
- Analog Lab mode
- DAW mode
- User mode
- Chord mode
- CV / Gate / Mod connections
- MIDI Control Center
- Connecting to MIDI Control Center
- MCC Controller Map
- Customize the Wheels
- Select the User Channel
- Customize the Pads
- Customize the User buttons
- Customize the Encoders
- Customize the Faders
- Customize the Select buttons
- Customize the Keyboard
- Customize the CV Modulation Input
- Customize the Pedals
- Customize the Pitch Out
- Customize the Gate Out
- Customize the Mod 1 / Mod 2 outputs
- The Device Settings tab
- Import and Export buttons
- Software License Agreement
- Declaration of Conformity
7.2.5. Parameters (in User Edit mode)
7.2.5.1. CV Pitch
Connector / User Edit mode name Parameter Range
Pitch Out / CV Pitch Mode Volt/Oct, Hz/Volt
BaseNote 0V [a] Full MIDI note range (default = C-2)
BaseNote 1V [a] Full MIDI note range (default = C 0)
Note Priority Low / High / Last
Bend range 1-24 semitones
Assign Part 1, Part 2
[a] These two settings are mutually exclusive
7.2.5.2. CV Gate
Connector / User Edit mode name Parameter Range
Gate Out / CV Gate Mode S-Trig, V-Trig (5V, 12V)
7.2.5.3. CV Mod Out 1
Connector / User Edit mode name Parameter Range
Mod 1 / CV Mod Out 1 Assign Any control (default: Velocity)
Volt range 1-10 V
7.2.5.4. CV Mod Out 2
Connector / User Edit mode name Parameter Range
Mod 2 / CV Mod Out 2 Assign Any control (default: Mod Wheel)
Volt range 1-10 V
Arturia - User Manual KeyLab MkII - CV / Gate / Mod connections 60