User Manual

5.4.3. Wheel modes
Press the Wheel button repeatedly to select the Wheel assignment:
• Matrix allows it to be routed to multiple parameters at the same time.
• Cutoff gives it control of the master cutoff frequency, so it's the same as turning
that knob.
• Vibrato connects an LFO to both VCOs, so the Wheel can add vibrato to the patch
without using the Mod Matrix.
• LFO 1 Amp lets the Wheel control the modulation amount of any mod route that
uses LFO 1 as a source.
Hold the [Wheel] button to access the Vibrato Options page. This allows you to set the Vibrato
range and specify whether the source will be LFO1 or a dedicated Vibrato LFO. For details,
see Settings [p.81].
5.4.4. Morphée modes
Press the Morphée button repeatedly to select the Morphée assignment:
• Matrix allows each of the axes to be routed to multiple parameters at the same
time.
• Arp / Seq lets Morphée Morphée randomize the sequence or arpeggio with Spice,
Dice, and Ratchet:
◦ Spice (X axis) alters velocity and octave without transposing the pitch.
◦ Spice (Y axis) alters gate time.
◦ Ratchet (Z axis) subdivides the steps with multiple triggers as
pressure increases.
◦ Dice: Swipe 3 fingers to "roll the dice" and randomize all of those
parameters at once.
• Morph enables morphing on the X/Y axis between sounds A + B. Several response
settings are available: hold [Settings] and touch the Morphée surface, or hold the
Morphée button for about 1 second. Descriptions are here [p.92].
Arturia - User Manual PolyBrute - Performance Controls 39